Cisco路由器配置入门知识大全
- 网络技术
- 关注:6.42K次
路由器是计算机网络技术中重要的.组成设备,小编刚刚接触cisco路由配置,下面是小编学习的笔记分享给大家,感觉命令还是多敲才能熟悉,希望对你有帮助
一、 所处状态各类
router>
用户处于用户命令状态,可以查看网络和主机
router#
用户处于特权模式,可以查看状态,还可以看到和更改路由器的设置内容
router(config)#
全局配置状态,可以设置路由的全局参数
router(config-if)#;router(config-line)#;router(config-router)#.....
处于局部配置状态,可以设置路由的局部参数
二、配置端口ip
命令
en
config t //全局模式
interface f0/0
ip address //设置端口ip
no shu //生效
exit
interface f0/1
ip address
no shu
exit
end
disable
三、配置静态路由
命令
en
config t //全局模式
ip route //到通过接口
end
show ip route //可以看到前面标明S,即为静态路由
四、配置动态路由(RIP)
命令
en
config t //全局模式
no route rip //禁止rip协议
route rip
network //network参数为路由的两个端口对应的网络地址
network
exit
end
disable
五、配置DHCP
命令
en
config t //全局模式
ip dhcp excluded-address //需要排除的ip地址
ip dhcp pool gr-dhcp-pool //ip地址池名
default-server //指定dhcp服务器
network //配置网络
dns-server //配置dns服务器
exit
end
disable
可以通过 ip helper-address指定 DHCP中继代理
interface FastEthernet0/1
ip address
ip helper-address 配置DHCP中继代理,DHCP
六、配置NAT
命令
en
config t //全局模式
interface f0/0
ip address
ip nat inside //内部端口
no shu
exit
interface f0/1
ip address
ip nat outside //外部端口
no shu
exit
access-list 1 permit any //设置一个可访问列表
ip nat pool gr-nat-pool netmask //设置分配池
ip nat inside resource list 1 pool gr-nat-pool overload
show ip nat traslations
clear ip nat traslation *
- 文章版权属于文章作者所有,转载请注明 https://xuezhezhai.com/jsj/wl/2p29pd.html